At Thirsties we always say diaper laundry does not have to be complicated: -Prewash on warm -Wash on hot -Add another rinse. However, during your cloth diapering journey, you may need to tweak things within your wash routine like load size, water level, detergent, amount of detergent etc. Here is a list of signs that indicate you need to tweak your wash routine as well as the possible causes behind them.
Sign: Diapers stink after coming out of the dryer.
Diapers did not get clean enough.
- not enough agitation
- not enough water
- not enough detergent
You need to clean your washing machine.
“I had to add in a towel to improve agitation. I couldn’t figure out why they weren’t coming out super clean, came to the groupies and looked through old posts and found that suggestion – works great!” -Krista C.
“I had to switch to a stronger detergent in our prewash. We never had major issues, but sometimes things didn’t smell 100% fresh. Once I made that change and used a longer main wash cycle, things come out so so clean, and I don’t get a faceful of ammonia smell between the prewash and the main wash.” -Svetlana N.
Sign: Diapers stink when freshly peed in.
- Hard water (180ppm or higher requires softener)
- Not enough detergent
- Not enough water
- Nighttime diapers need rinsing
Too many diapers in wash loads.
“I suspected something was off (They started to have on off smell when the babies would wet their diapers) so I had to interrogate my husband to find out that he had been leaving off the extra rinse! On purpose! Because “it seemed long enough without it.” Trust no man with your wash routine, ladies. 😂” -Kayla R
“Once kiddos became about 9 months I had to begin rinsing night diapers to avoid ammonia build-up. And again when they began to potty train and use less diapers I had to tweak my routine.” -Ashlea F.
“I had to add more detergent to my prewash when my baby became a toddler 😭 I was getting ammonia stink.” -Katie D.
Sign: Fast developing edge wear
Too many diapers in a load
Not enough diapers to rotate use between.
Washer’s spin speed is too fast.
“I was getting crazy edgewear and realized that I was putting too many diapers in my top-loading washer(old school with an agitator). I could tell it was too many because the pocket inserts wouldn’t agitate out and my prefolds would come out all twisted.” Mackenzie W.
Sign: Change in location, Change in your washing machine
Different water hardness / softness
Different water levels
Different agitation mechanism
“I’m in the process of completely changing my wash routine. We just moved from pretty soft water to a place with really hard water. It is crazy what a difference water hardness makes. Still tweaking here and there but I had to change the detergent and the amount I was using, adding water softener, and eliminating the extra rinse at the end that was needed for softer water.” – Kim G.
“We moved from a house with an HE washer to one with a standard washer. I figured out after a few loads of stinky diapers coming out of the dryer that I need to use more detergent since I didn’t have an HE washer anymore. (I actually like this washer better than the HE now that I figured that out! – Kelli D.
Sign: Rashes, Irritation, Red marks that don’t go away on legs or pressure points where diaper hits
Potential Cause(s): These issues could be a factor if you have ruled out potential fit problems.
Ammonia Build Up
Detergent Build-Up (Check if there are a lot of suds in the final rinse cycle)
“My kids have detergent sensitivity. They get red splotchy rashes in their diaper area. We actually had our doctor check it at one point to make sure that was the cause.” -Danielle W.
“After following bad wash routine advice (not Thirsties), too much Tide caused a chemical burn. It looked almost like a sunburn but instead of flaking off the skin peels off and is a big open sore where the diaper touched.” -Cheyenne S.
Remember there is a solution to every bump in the road on your cloth diapering journey. Thank you to all the Thirsties Groupies who shared their cloth diapering experiences with needing to tweak their wash routines. Remember, we are always here to help troubleshoot your wash routine so feel free to contact us at email@example.com.